Recent content by 69GT

Thank you Mr. Sinister! I'm hoping to find one with really nice chrome as the other three I have are in very nice condition but if I don't, I'll take it. :thumbsup:

This is what mine looks like on the back side.

The part number is 3882765.

Thank you very much for the offer but I would like to have all four in the set match.

I'm looking for one window crank handle like shown in the pic. I'm not exactly sure what model year used this style but I think it may be 73-74 or possibly even later. I bought a set of four of these a few years back for my Dart and now that I have finally reached the point of installing my...

I found out today the repro sidemarker lenses I bought years ago for my 69 Dart don't fit. I guess they fit all the other cars just not Darts and station wagons. So, I'm looking for a new pair of lenses if anyone has a pair they don't need.

I still need this part if anyone has one.

Obviously, the seat release handle is on the outside track. That's not what I'm asking. What I wanted to know is if the tracks would still work properly if they were installed on the opposite seat by mistake. On my seats, right now as they are in the car, the driver side release knob moves...

I'm putting the bucket seats back in my 69 Dart and have a question. I took the seats apart years ago to restore them and now that I have them back together I'm wondering if I may have installed the tracks on the opposite seats. With both seats all the way back, the passenger seat sits a little...

Kim, The rods in your 4th picture look like the type I need as they have the pin (or whatever it is called) on each end that uses a retainer type clip that snaps on to the rod. I measured my bellcrank and trans. lever holes today. They are the same size. I guess they would be considered 1/4" but...

I'll measure the holes today and let you know. The rod I show in the picture is from an original set of 67 GTX 440/727 linkage that was removed in favor of a Lokar cable.

Thanks for the reply. It certainly looks similar but I'm not sure if I could squeeze the extra length in there unless I have some extra play on the bellcrank. There is a small amount of wiggle room on the trans. lever but not that much. Hard to say without trying it to see if it fits.

Looking for a big block 727 bellcrank to kickdown lever linkage rod like this or similar. Doesn't have to have the same bend in it as shown in the picture but the length needs to be the same as well as the ends where it attaches to the bellcrank and trans. lever.

1970/71 Year One big block spark plug wire separator bracket kit WR43. I bought this for my 70 GTX and sold the car before ever installing it. There is surface rust on a couple of them (from humidity while in the plastic bag), mostly on the one that mounts at the front of the intake. $50 +...

Two unused big block head pipe to exhaust manifold flanges. $15 for the pair. Unused/unopened big block exhaust manifold stud kit. Although the bag is unopened, I can see some surface rust on some of the pieces. $40 or $50 for both. Prices do not include postage. No Paypal.