SlantedDart's latest activity
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Got some progress going on. Got the rear end in and assembled. Came out pretty good. Minimal swearing. Had the custom pilot bearing... -
-
SlantedDart replied to the thread Gen3 hemi tkx swap.There is. Didn’t tack them in yet in pictures
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Got one spindle welded up. All looks good. Track width will come in about a 1/4 inch have to countersink the ball joint bolts. Just...
-
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Hopefully . I’m going to to some R and D with them first. Take them on a drag week and drive them around Michigan. If they survive that...
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Spindle parts are in. Waiting on custom pilot bearing then trans will be going in.
-
-
Please post pictures of the parts before welding as well as after. Dying of curiosity to see it. :thumbsup:
-
That's a nifty idea! Does the fact that it ends up a tad shorter cause any issue?
-
SlantedDart replied to the thread Gen3 hemi tkx swap.No, it’s already longer than the A arm. Better to have a bigger swing. Helps with the arch
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Been putting the front suspension on. Hdk kit is very nice. I had stock strut bars in it with the factory rubber so I made a front...
-
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Thanks. I’ll keep them coming. I haven’t found a stepped pilot for this application. I’ll be running a 255/60 drag radial with 4:30 gear
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Got some good news I guess for the bellhousing. We are going to use it. I’ll have to make a custom pilot bushing that’s a little longer...
-
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Crank on the gen 3 only sticks out .500 from block not like the old school stuff
-
QuickTime use to make the right depth bells for the small block Mopars for the Ford and Chevy input lengths for the Tremec trans. but...
-
Which TKX trans did you purchase? If you purchased the the Ford version, it has a 7.21" input shaft length. The GM one has a 6.71"...
-
SlantedDart replied to the thread Gen3 hemi tkx swap.Ford version. Well that would explain the shortness. Story of my life eh lol. They advertise it as small block/ gen 3 tko/tkx when they...
