Search results for query: *

3, ramcharger 4wd ball joints. 2 lower and 1 upper. These were for my 87 and dont know how I ended up with extra. Asking $40.00 shipped to a US postal address

2 used Ramcharger fender emblems. 1 has a missing location pin but still usable. Asking $30.00 shipped to a US postal address

Header wrap tape. I think it's fairly close to a full roll. I dunno, used it on my old Harley years ago. Asking $20.00 shipped to a US postal address

I have 2 DeWalt 18v drills. One is hammer, other is not. Has 1 battery and charger with them. They worked, just upgraded to the 20v version for work. Asking $45.00 shipped for them

4wd ball joint service set. I used it once on my 97 Ram about 5 or so years ago and sitting since. Asking $60.00 shipped to a US postal address

Brake proportion valve. Unknown condition. I sprayed brake clean through it and didn't seem dirty coming out. Asking $45.00 shipped to a US postal address

New Mopar Performance M1 magnum intake manifold. It is the dual plane, 4bbl version. Part numbers can be seen in the pictures. Has not been bolted on and will come with MP gaskets and bolt set. Asking $600.00 plus shipping charges

Holley 50cc accelerator pump kit. New and appears to be all there. Asking $60.00 shipped to a US postal address

I missed a few days, but the upgrade to pictures in the classified section are amazing! Bravo to whomever's idea it was. Now, I need to spend half of my morning scrolling through all the ads now.

Small block 3 piece kick down linkage set. Was for a 2bbl, but can be easily modified for a 4bbl. Asking $135.00 plus shipping charges

used hood pins. Missing one pull pin Asking $10.00 plus shipping

I have 3 steering couplers. 2 are .60" shaft and 1 is .70" shaft Asking $5.00 each plus shipping

I have 3 brake pushrods. 2 with the bolt and 1 without. All 6.5" long Asking $10.00 each plus shipping

Used 3/8 oil or transmission cooler. I have no use for. Asking $25.00 plus shipping

I have new brake line set and wire harness clip set that's unopened and a partial 3/8 fuel line set. Asking $23.00 shipped

Brand new small block, Chinese airgap intake. Never installed. Asking $130.00 plus shipping charges

God morning all! My 87 Ramcharger has a MSD ready to run distributor in it. It's a stock 318 other than dual exhaust and 4bbl. I just cant get more than 30* Mechanical advance out of it. Initial is at 15* and with vacuum it go to 50*. I changed the stop bushing from 21 to 25*. The springs I...

I have a Holley 700 double pumper carb. I went through it for my car and bolted it on. I couldn't get my linkage and drop base aircleaner to work with it. I wasn't about to buy another one. Changed directions and put a 3310 on it instead. It is ready to use. Bolt on and go. Has new PV, gaskets...

Mopar books as shown in the pictures Asking $100.00 shipped priority mail, to a US postal address for all of them

Haynes, Harley Davidson twin cam service manual. Asking $28.00 shipped priority mail to a US postal address

4 hole, pheolnic carb spacer. 1" thick. Asking $36.00 shipped to a US postal address

Magnum intake manifold. Was going to use it for my 97 Ram's spare engine, but will now not use it. Asking $50.00 plus shipping charges

Vintage Sun oil pressure gauge and cup. Asking $50.00 shipped to a US postal address

Everything in the pictures is $15.00 each except for the strut rods, and fender struts since they are a pair. The trans dipstick tubes the center does not have the stick but the others do. The trans yokes are 904. Fan spacers has the sizes on then. Pullies the same. The steering stabilizer was...

Edelbrock 1902, 750 cfm Quadrajet carb. Looks new inside and out. Some screws has some surface rust from sitting, but will not effect it any. Bought for my Ramcharger but I can't get the choke mechanism to work for me. (Operated opposite of Mopar) Asking $300.00 shipped to a US postal address

2-1/2" flowmaster clones. New never used. Came in an exhaust kit I got. I don't like the sound of them and went with magnaflows instead. The dimensions are on the boxes Asking $70.00 plus shipping charges

Holley 650 vacuum secondary, electric choke carb. It is very clean on the inside. I replaced the power valves, accelerator pump and some gaskets on it. Should be ready to bolt on and go. I was going to use it for my Ramcharger. Just changed my mind about changing carbs on it. Asking $160.00...

Mopar performance chassis book, big inch small blocks and A-833 transmissions. Asking $100.00 for all 3.

I purchased a steering wheel from this guy on Facebook for $200.00 shipped. After a week I message him asking where it is. He said the shipper sent me an email. I find it in my spam folder and they (International Shipping Courier) say they require a $200.00 shipping insurance deposit that will...

Front fender braces for A body. Asking $25.00 plus shipping charges