Recent content by Inertia

Got my front and rear bumpers there. 3 chrome vendors. Inspect them carefully, I got the only "good" ones, lol

Cuz of the new China tariffs and the likely repercussions, they will probably restrict all the "rare Earth's" and many minerals nec for solar and chip manufacture, I bought shares of a small miner I mention a while back 5N+, I'm up about a $1 on a $4 stock, They produce rare Earth's here in...

Went up to 6 during Covid, now down to less than 2? I am very much trying to leave politics outta this thread. I'm very glad you're doing well. NVDA almost back to $1000 again, the whole market is broadening out. Fear of a rate increase is gone, tons of great earnings . Looking pretty good for...

I kinda think it's all related in a way. Companies becoming more cost effective. Lotta small marginal companies counted on running on a line of Credit, to pay bills, etc, wages, etc. The butcher, baker, - candlestick maker all had thousands $$$ at their disposal. I did, all my businesses since...

If any of you picked up some Cannibix stock (BLOZF) back when it was 18 - 20¢, it's now over 60¢. This stock was only trading less than 60k shares a day, now over 1 million . By my discipline, you should sell 1/2, let the rest ride till they are mandatory by all Police and companies requiring...

I could spend a week in Balboa Park, San Diego.

I had a a Challenger bblk, I had to take a belt sander to the head flange to get it to fold under, kinda like this one. That header was fkd, but I got it to fit. The old days were a nightmare, no 2 headers were the same, hand welded, flange was like a mountain range, weld/ file every set. At...

I use a $5 piece of chain, from hemis on down wrapped in black tape, no vibration, lotsa horsepower, lol

I'm often happy with 1/8th clearance, depending on torque side and mount condition. No rattles, no leaks, no dings .

Most auto parts stores will have a multi-compartment box behind the counter with both US and metric plugs. If you drilled a hole in the plug to remove it, braze/weld the hole, or put the screw back in. Or just leave the whole thing alone, you have oil to the top, you always did, (put the 2 bolts...

You're kidding, I'll be in touch, thnx

Bob, that pic in post #24, - which tube is that, what cylinder ?

I've got some 40 yr old, I'm afraid to try, lol

I think a lot of us gave Thanx to Timothy Leary, I did .

Just a side note, I had a coupla engines break rocker shafts. The oil pressure gauge banged off "0" psi at 1/2 engine rpms. So pump resistance should reduce a bunch as the passage opens.