LJ67barracuda340's latest activity
-
We use the one piece seal on all big block Mopar engines. Sometimes they work, sometimes they don't, but it has been the most successful... -
I usually end up around 35* on street/strip BBM. As for the seal, they all take a 2 piece. However there is a one piece available. I...
-
LJ67barracuda340 replied to the thread Need big block help.One more question please, the rear main is leaking a bit. I think a 440 has a 2 piece seal but does a Wedge Mega Block have a 1 piece?
-
LJ67barracuda340 replied to the thread Need big block help.What is a general total timing Big blocks like. 34* like a Small block? Every engine is different, I know.
-
Larry, my 500 dyno'd at 550 HP and 610 TQ with iron heads, and one step larger comp cam. The same shop built another engine after mine...
-
LJ67barracuda340 replied to the thread Need big block help.i'll look tomorrow but right now I think its Indy EZ. The dyno sheet was run with a carb not the EFI and the timing is locked out and...
-
LJ67barracuda340 replied to the thread Need big block help.So just to finish the info on this mega block engine. It isn't a siamese block which is good for us. I dont know if the pics of the dual...
-
-
LJ67barracuda340 replied to the thread Need big block help.I thought it was 71 because I found 12-6-1 cast on the block. After reading the Mega Block write up I'm sure that's what the block is...
-
this thread says its a mega block. NOS Block 2468330-M ID?
-
LJ67barracuda340 replied to the thread Need big block help.I am aware that the EFI is totally separate. We were just doing detective work on the engine. I'll post the dimensions and dyno numbers...
-
LJ67barracuda340 replied to the thread Need big block help.No I'm not sure, every web site I looked at said 426 Hemi. The engine is built and running for a few years now in the car (63 Sport Fury...
-
I'm new to BBC (been SBC for life to far) and I'm trying to sort out a friends FiTech system. Also trying to figure out his engine. He...
