rmchrgr's latest activity
-
rmchrgr replied to the thread U-Haul car trailer experience?.The trailers are actually decent, I've used them a several times. I have had it happen more than once where the ratcheting tire straps... -
rmchrgr replied to the thread Headliner or Glass... Which should go First?.110% install the headliner before you put the glass in, especially since you already have the glass out. IMO, it's not even a choice...
-
rmchrgr replied to the thread Distributor Rebuild Question.Glad you were able to work it free. My apologies for suggesting the cam and plate were two separate pieces, that was obviously 100%...
-
rmchrgr replied to the thread Distributor Rebuild Question.It might just be really stuck. The lower shaft pin only holds the collar in place. The little i.d. circular clip holds the T-bar to the...
-
rmchrgr replied to the thread Gen3 hemi tkx swap.Maybe I misunderstood but he asked specifically how much travel the throwout bearing should have? The concept is simple and should be...
-
-
rmchrgr replied to the thread Gen3 hemi tkx swap.Shouldn't be a lot. Isn't there a spec in the instructions? Several years ago I put an American Powertrain hydraulic throw out bearing...
-
-
rmchrgr replied to the thread Builders: Square engine, Over Square, or Under Square for you?.Over square every time. The quote below is from Darin Morgan; "An oversquare motor is absolutely superior at high rpm compared to a...
-
rmchrgr replied to the thread 360 vs 383.OK but you used NHRA specs to make a point and used them incorrectly at that. Calculators are tools. Mock them all you want but I’ll...
