66 Dart Owners thread

toolmanmike said
I talked to my neighbor who owned a pattern and mold shop. The dies cost thousands to produce. You need a left and right and if done right, trim dies to get closer to a finish product. Just to produce the forming dies might be $10,000 each. Overseas would be the best bet. (I would hate to go there) It might pencil out in the long run (100 bezels X $100 each would pay for a forming die)

That does sound more approachable when you consider the math (100 at $100 a piece) but the hard part is the initial investment.... I wish I was in a better position to consider being an investor in this. I wonder if one of the vendors would be interested in footing the bill in lieu of doing the legwork?