How much CFM for a 360?

MOhorsePAR said
Hello everyone, O:) Long time reader, new member.

I purchased a motor from a buddy of mine a while back with less than 500 miles on a new build. It is a 360 +.030 with approx 9.8:1 compression, Comp XE-274 cam, air gap intake, Hooker headers. It currently has a 600 CFM Edelbrock that runs quite nice on the street.

However the question I have is this -
Is that enough carb for the motor / cam combo? I expect to the car to see mostly street with an occasional pass at the track.
Your thoughts on which carb to run and why,,,,,

Thanks!
Steve

That setup isn't to far off of my setup. 600 is ok for the street but you will not be as much fun for racing. I actually started out with a 750 Edel and I hated it so much I could never get it tuned in right with the engine. I tried a 600 a buddy had and it tuned up nicely but it had nowhere near the balls it did with the 750 when the 750 actually wanted to run right. I ended up getting a 650 mighty demon recommended by by a few others from this site and been very happy since.