Search results for query: *

What condition are the gears in? Can't tell from the picture. Any more info you have about its condition would be helpful. I am in the 93420 area code; this is where it would need to be shipped.

I'm very interested. Any more pics?

Lou, its David Montanaro; please contact me by email or phone: [email protected] (805)459-7303

Sold! Please contact me to arrange pmt/shipping, etc.. Dave [NO phone #s. Use the message feature]

I would like to buy this part. I would like to know if it needs any work or if it's ready to install. Thanks.

Is this unit sold? I'm working on a '65 cuda with the rear end you're looking for to roll your car around on and I'm in need of this rear end.

I've got the same car and went through what you're going through. My 273 had low compression in a couple of cylinders, barely ran, and the 904 cable-shift leaked. I decided to do a 360 magnum engine swap and have since learned how quickly the $$$ add up. When my project is done, it'll have a...

I'd like to use this part on my 360 magnum build. Is it for a 360?

looking for four-speed pedal assembly for '65 cuda. Do you have?

still have the pedals?

padal assembly still avail?

What's left?

I'm Very interested... Will this fit in my '65 Cuda? If you provide me with measurements from outside to outside of breaks and outside to outside of perches I'll compare

Sold

I would like to buy these from you for my '65 cuda.

I'm very interested if it's still for sale. I am close enough to come and pick it up. Please let me know. Thanks

Still have the engine and trans?

Any idea what it would cost to ship this engine to California?

Good info here. I've been looking for a Magnum 360 to swap into my '65 Barracuda and found that my Brother-in-law has the same jeep you've used and agreed to donate it to the cause... Thanks for the wiring diagrams!

Will this fit in my '65 Cuda with 904 cable shift tranny?

Oh yeah, forgot to include that this is for my '65 cuda...

Good stuff guys! I'm looking to upgrade my drums (front) to disk as well as change out the bolt pattern to 4.5; questions are: 1. What conversion kit should I get or should I look for the vintage 4-piston setup and do the above mustang conversion (money's an issue...); 2. The last post...

Sorry about the last post. Meant to send a quick note to one of your reply's sender. Great thread though and good luck with your project.

I've got a '65 Cuda that I'm fixin' up. It does have a red interior and carpet that's in great shape except for in the trunk area so I may be interested in some of your parts. Also, the rubber for the doors is something I'll need. Do you know where to get the seals and "swipers" for the...

Hi guys, I've got a '65 cuda with a 2-barrell 273 and an automatic. The questions are: 1. How do I tell what transmission I have (I was told it is probably a 904)? 2. What rear end do I have? Your help is greatly appreciated!

Whatcha want for the manifold?

How much for the manifold?

My '65 Cuda has a 2-bbl 273 that's barely runs (low compression in #2 and #7). Parts for this motor don't seem easy to come by; especially performance parts. I like the idea of rebuilding the existing motor like a commando but I'm not really sure what it's going to take or where to get the...