Recent content by 73dart360

  1. 73dart360

    Trick Flow 240 and Track Heat intake hood fitment 70 Dart?

    Has anyone tried to fit the Trick flow 240 with the track heat Intake B engine under the hood on a 70-72 dart
  2. 73dart360

    Fort lauderdale Area -Good Mopar mechanic Needed

    I would appreciate that
  3. 73dart360

    Fort lauderdale Area -Good Mopar mechanic Needed

    I have a 70 dart with a new big block stroker motor i need to get dialed in ,i want to put a new Carb and valley tray also.
  4. 73dart360

    [WANTED] 1965 Dart- Horn Button

    Looking for a good 65 dart horn button
  5. 73dart360

    How to thread new turn signal switch harness ?

    i figured it out thanks for all the help greatly appreciated
  6. 73dart360

    How to thread new turn signal switch harness ?

    How do you get the 7 wires from the new wiring harness down through the steering column I taped them together they are too bulky to fit through can anybody help figure out how to get the harness down and I used a wire to pull old harness up through I had to cut ends first I then attached wire...
  7. 73dart360

    65 dart signal switch harness?

    The Original 8 The receiver has 5 receiver ports on top and 5 bottom 10 total
  8. 73dart360

    65 dart signal switch harness?

    So would I just plug into one of the open recepticles does it matter
  9. 73dart360

    65 dart signal switch harness?

    I just purchased a new signal switch and wiring harness The New one is the first picture it has 7 wires the old harness has 8 wires , some are different colors need help don't want to take it apart more than once
  10. 73dart360

    How do I remove defrost vent on dash?

    there was no way to access the nuts because of the air conditioning unit ,I broke off the studs very easy saved a ton of time
  11. 73dart360

    How do I remove defrost vent on dash?

    thats what i did it worked great and saved a bunch of time greatly appreciated
  12. 73dart360

    How do I remove defrost vent on dash?

    I got it ,i took a gasket scraper and broke it up ,the screwed thread for the thin nut is plastic that is molded into the vent so when you brake the plastic you can brake off the threaded stud you push on the broken with a screw driver stud it falls inside on the floor.
  13. 73dart360

    How do I remove defrost vent on dash?

    A 4-in crescent will not fit in there it's tight I think maybe starting to snap off the top might be an idea
Back
Top