Recent content by Boduke

Yup mo is fine Or check Lemme clear my inbox sorry abot that

$20 shipped Came off 72 No payPL

Ha! My bad

$20 shipped Check or MO only Came off 72 Idk what years interchange

Dr diff- new never used. Ill include washers Nuts and castle locks Ill toss in the caliper brackets, caliper bracket bolts and the backing plate bolts $80 shipped flat rate box Check or m.o. only No paypal https://www.doctordiff.com/reproduction-disc-brake-knuckles.html

Bro.. if u got the stones, cut it up and burn it down.. showcase ur skills. Prove all the haters wrong, engineer it and make it work. Post pics for all the followers that come after. Be the legend everyone else is just sitting on their phone talking about..

Only pass side needed it on mine Both bolts got one washer each. Stock bolts. Using stock eccentics only its give and take with respect to caster /camber.. i could not just set each independent of the other. Toe is its own thing. So u have to give up one to get more of other. Every time i set...

1/8 ish.

Yes to give more - camber. without using the eccentrics, so..set for max caster with back cam all the way in and front cam all way out.. Then.. check camber.. if its + you can shim it rather than adjust the cams whereby losing caster.

I installed the lca and strut rod assy loose on k member and ran it thru the motions. But im sure there is prob more scientific method. And im all factory stuff

Genius!

So i just ran outsode and butchered them with hacksaw. I think im prob going back to no lower bumpstops. I ran none for years without issue. Def not correct. Def not adviseable.

word! I was actually thinking there.

72 dart running 6cyl torsion bars with 318.. i have the ride height set at 1-3/4 between the lca and the fram. My rock auto bumpstop is 1-3/8. Leaving me 3/8” of travel.. i may have set the ride height low but i like it where it is. Question.. how much should i cut the rubber bumper ? Or how...

Dont forget the mystery holes in the front. I chased that leak for a weekp