Figure it out wrong wiring harness for year!!
Need help guys when I turn the ignition key to start the horns go off and nothing happens. Also when I bypass the Neutral safety and turn the key 1 click the motor turns over . I have no clue what’s going on. Also what are these wires for ?
Okay this is a factory harness that previous owner butchered bad. From the diagram that you posted I should be fine then?? That black wire instead of from the alternator is coming from the positive post on the battery. Would this be fine? The one wire alternator I am running has a 2 gauge wire...
Okay I ran the black wire that was suppose to go the alternator because I put a one wire on it and now I have power and everything is working. Is this okay if I leave that wire connected to the positive pattern post ? Also when I turn the key to start it the horn beeps but I will figure that...
I have no power anywhere except 12v to the starter relay. All the fuses under the dash are good. Ground from the motor to the chassis. Ground from the battery to the motor. Nada nothing what am I missing? Also put a single wire alternator on it as well. If that helps. Not sure where the wires...
Okay I cut these wires off tied them together under the hood and ran a pink 20 gauge wire to number 16 nothing. When you say together at the key are you meaning under the dash as well ? I’m also assuming the dark blue with no end on it was the one to the coil as well ?
It’s the holley set up for ignition all of it the complete system and thank you this info is perfect. It’s the pdm Holley distributor fuel pump everything. Does this picture help ? So tie those 2 together and then run the coil wire to #7 the “pink” wire on the pdm box then should he good to go ?
Hey guys need help in identifying ign 1 and ign2 on my wiring harness when I got the car it was in boxes my dad and I rebuilt it and I’m putting a sniper2 on with the pdm and all the bells and whistles . Everything wired and I want to try and start it. From the research I’ve done it says I need...
Will this system clear mini tub and frame connectors ? My sons building a 67 dart and I put this system in his brothers 81 Camaro they are beautiful systems and easy install. But this 67 has the side strap for the gas tank and subframe connectors and mini tubbed any help would be appreciated.
My son has put a set of later dual hood scoops on his 67 dart and put a 440 in it does anyone make the 440 emblems for the hood scoops aftermarket ? I can find the 340 ones but nothing else thank you
No I looked at that as well numerous times but iam burning the candle at both ends these are the directions I got with the mounts. I think I have them right. But I did notice that the motor is sitting kinda crooked on the k member. Not sure if that’s normal or not. Or maybe these are the wrong...