Recent content by Litz

Yeah street/strip drum brakes all around

Posted a photo

Yes, it's a street car with drums all around

I'm having a hard time figuring what would be a good upgrade from the old single pot MC. Looks like the headers will be very close to the MC. Any suggestions/advice would sure be appreciated. Thanks in advance.

I have to thank you for the schematic that you sent me! 3 minutes and I found the problem. almost embarrassed to tell you what it was. I had the two main wires going through the bulkhead reversed. Your help saved the day. I also have a service manual coming for future reference. Thanks again, Litz

Thanks again for your input. I really appreciate it.

I'm having charging system problems with my 65 valiant and am in need of a good service manual and thought maybe you guys could point me in the right direction thanks in advance.

Thank you for the info. I have never seen anything like this. Batt. fully charged anything above idle and the amp guage goes way up. about 40 plus amps. And I cant get the guage to show discharge. Engine off, headlights on high beam and radio, etc on and the needle doesn't budge. The wiring is...

I'll try and make this as short as possible. Prior to the repaint everything on the car worked as it should. I removed all of the wiring from the bulkhead forward prior to painting leaving all components attached to the harness. After painting I cleaned and inspected all of the wiring and...

I used the truck mounts. Super easy to adapt. Thank you so much for your reply!

I need some help/advice on where I can purchase some new motor mounts for my 65 Signet with the factory 273. The only ones I can find are too thin. My originals are way thicker and I need the original style for header clearance. Thanks in advance, Litz

I got a VFN hood for my 65 Valiant. good quality and workmanship. I would recommend them.

Thank you Phillip I will be calling you in the next week or so.

I am also trying to find a source to purchase the early A Hedman Husler fenderwell headers. Tried hedmanhusler.com and couldn't find any info. tried both part numbers mentioned but came up empty. Any suggestions?

Looking for a good machine shop/Mopar engine builder in the Deer Park, WA. area. Also someone with welding skills to help with chassis mods on 65 Valiant