Recent content by MRGTX

  1. MRGTX

    modern muscle

    The definitions are fun to debate. Guys, keep in mind that it’s probably time to open the category and allow more cars to be called muscle cars. All of our cars are slow now. Just about any basic electric car would smoke any stock classic muscle car. The higher end EVs smoke every short of...
  2. MRGTX

    modern muscle

    IMO, you can't go wrong with a modern Challenger 392, Camaro SS, or Mustang 5.0. They're each spectacular in their own way. In my opinion: Challenger looks the best, has the best sounding motor (6.4L/392) Camaro drives the best- probably the quickest in the real world, handles awesome. Mustang...
  3. MRGTX

    17" versus 14" tires

    The conventional wisdom about more tire choices on 17s may not be quite what it sounds. Yes. there are modern/sticky tires available in 17" but if you're looking for a 17" performance/non drag tire that is taller than 25" (as most of us are) you have your work cut out for you. At least that...
  4. MRGTX

    Can small block oil pump be replaced without pulling the engine?

    I have a Magnum-based stroker and I will be replacing the oil pump in the coming weeks. I have a engine hoist on hand and two engine swaps for this car under my belt but none since the 4spd conversion (not sure if this is better or worse)... but frankly, I'm just trying to figure out if I can...
  5. MRGTX

    The dreaded fiberglass hood sprung spring rattle

    Coming back around to this issue...now that another driving season (for us northerners) comes to a close, I am writing up my list of things that have to be done before next spring! Speaking of spring (har har) I came to the conclusion last year that I am going to have to pull the...
  6. MRGTX

    Low oil pressure on new engine solved

    Isn't this still too low?
  7. MRGTX

    Got a Couple of Beauties from Target - 73 Duster & B-Body AWB

    I love this Duster mold. Previously, I was only aware of the Sox and Martin version (which I bought at significant expense a few years back). Thanks for sharing this...I need both of these. :D
  8. MRGTX

    Magnum oil filter block plate - source?

    This is a good call. The mating surface looked clean from what I could see from beneath/behind the front wheel with a spot light.
  9. MRGTX

    Magnum oil filter block plate - source?

    I picked up some permatex black gasket sealer, coated the gasket and gave it another go. It’s still absolutely pissing oil. I noticed that the plate may be damaged…not only is the mating surface a bit wavy, it appears to be lopsided. Does this look wrong?
  10. MRGTX

    Magnum oil filter block plate - source?

    I can’t quite see the casting info with the headers on. I wish I took a picture before I put it in the car. If necessary, I’ll unbolt the driver’s side and take a look. I do know that the block is a Magnum 5.9.
  11. MRGTX

    Magnum oil filter block plate - source?

    Thanks to all for the input! I was able to obtain one…I installed it carefully with no difficulty, fired up the engine, saw no oil pressure issues, backed out of the garage, drove a few hundred feet down the road and noticed that I was leaving a STREAM of oil behind!!! Obviously, I headed...
  12. MRGTX

    Show your wheels

    Is there a model for either of these tire sizes that you have in mind? Both sizes seem pretty unusual. I realize that Tire Rack doesn't have everything but I was curious and took a look 305/45/17 I only see one tire, NITTO NT555RII but it looks like a good one. 100 tread wear...can you get...
  13. MRGTX

    Show your wheels

    They look good to me…but it also looks like the OD on those 315s is only 25.7” (give or take). The performance tires seem to max out at this diameter which is too short for most of us. This is the main reason I gave up on my 17s. What’s your final drive ratio?
  14. MRGTX

    Show your wheels

    I painted the Rota RKRs. The original charcoal finish was what I wanted six years ago but after looking at them for so long, it was time to change them up. No regrets so far. Before anyone asks, the rears are 15x8 0 offset and the fronts are custom and not available off the shelf.
  15. MRGTX

    what dia t bars should I buy? & what shocks should I get?

    Go do a full coil spring conversion. KIDDING!! This is my setup exactly...I have to report that it rides hard and still doesn't feel that great. If I had to do it over again, I might go for a smaller torsion bar.
Back
Top