Recent content by slowfab

I know where your coming from. I have had the wiring harness clips melt from the radiant heat off the headers just idling in the garage. There are some pretty nice carbon hood extraction vents for other brand cars out there.

First I have seen them. I have used their SBC headers in the past and modified to work on a SBM flange. A 1.5 primary tube is pretty small for any kind of serious build.

On mine I had to go to a Hall effect sensor. The magnetic pickup was not very consistent. Not sure what style you are running.

Thanks. The next project will have plenty of fabrication but lots of wiring also

Thanks. I would post a video of it running but it seems only pics can be posted here

Yeah, we definitely need to check each other’s cars out.

Here is the engine compartment done except it now has a thermostat in the upper hose.

Not at this time. I hope I don’t in the future as that means I have had issues

I finally got the car together and on the ground. It runs now and just need to start dialing in the efi. It’s just cold up here and snowing on and off now. This keeps me from doing too much.

Not sure. I am thinking they are for a oem bezel. If you have some measurements, I can check.

I have a old but new lower dash wood grain stickers. The point is slightly bent but probably fixable. 20.00 plus the ride.

Sold. Thanks fabo