SRT8CUDA Build
My ride height was pretty low and I sometimes bottomed out on the header flanges, so decided to raise the car a bit. I moved the rear shock mount up one position to the top position which raised the back of the car 1-1/4", but that looked too high. Then I adjusted the coil-over shock springs down by 1/2" and it looks a lot better. You do have to be careful adjusting the ride height on these shocks to ensure that you keep the shock near the center of it travel. Next I have to raise the front end, but will do that after Moparfest in New Hamburg Ontario this weekend Moparfest – Canada's Largest All Mopar Car Show , since it will screw up the alignment.
My ride height was pretty low and I sometimes bottomed out on the header flanges, so decided to raise the car a bit. I moved the rear shock mount up one position to the top position which raised the back of the car 1-1/4", but that looked too high. Then I adjusted the coil-over shock springs down by 1/2" and it looks a lot better. You do have to be careful adjusting the ride height on these shocks to ensure that you keep the shock near the center of it travel. Next I have to raise the front end, but will do that after Moparfest in New Hamburg Ontario this weekend Moparfest – Canada's Largest All Mopar Car Show , since it will screw up the alignment.