2-Barrel to 4-Barrel Conversion

WV64Signet said
Tried moving the linkage arm from inside to outside but the clip will only fasten the way it is currently.

Installed the 340 cable bracket and didn't like how it came up under the linkage as well as how far out of alignment it would be to the connection point of the throttle cable.

The angle from the clamp up is slightly more, but the alignment rear to front is far better with the 318 bracket.

View attachment 1716151977

View attachment 1716151978

View attachment 1716151979

View attachment 1716151980

View attachment 1716151981

View attachment 1716151982

View attachment 1716151983

There are right and left hand clips available. I have found them at the hardware store or possibly Menards. The threaded throttle pin is actually supposed to go in the hole in the adapter that you have the kickdown hooked to. The throttle goes on the inside (short side of the pin) and the kickdown on the long side (outside) Remind me again what transmission you are running and what kickdown linkage pieces you are trying to retrofit.