Recent content by 1969DartCustom

Awesome! Good looking out! I appreciate it!

I can use them!

They should be shorter and shouldered, perhaps 1.5 inches long, I am having a hard time finding a picture

I think so, the lap belts were still installed and I kept those bolts together. They are shouldered and two different lengths. I have some 7/16-20 1 /14 grade 8 long bolts that will fit but I’d rather have the original and shouldered to allow the top mount ( for shoulder belt) to swivel.

Unfortunately mine are missing and the shoulder straps as well. I updated to buckets and a 3 point seat belt but wanted to use the stock style hardware.

looking for two shoulder belt bolts. The ones that go into the roof section. I’m out in Northern CA. Thanks!

Has anyone installed a knee knocker along side their stock heater? Just wanted to get some ideas on. Punting location. I saw one posting with a knee knocker unit but it looks like the original heater box was removed. Anyone have a cool only unit that can share some pictures? My heater works...

I’ll definitely look into 1.03’s as well

I will grab the part numbers but I swapped from a slant 6 to a magnum 318. I bought some used 318 torsion v8 bars. I’ll look up the part number. Here’s an old pic of the ad If I recall correctly, they are .850 bars

I can always raise the height abojt 1 more inch to add more clearance to the bar. Should put me at 4 inches. From what I’ve seen, it appears the QA1 bars hang lower than others

torqued everything down and reset the cam bolts and tightened anything else that was overlooked. Looks like I’m heading in the right direction. Car is sitting fairly low. The sway bar is about 3.5 inches off the floor though. Car is not sitting on bumpstops and the A&B was set to 0...

Ah, I appreciate the info and reply! I got the manual handy and will read over the settings. I thought the QA1 system would be different but it’s pretty much a bolt on / OEM replacement. The car appears to be high since it’s on the jack stands. I torqued down the k member Bolt. I didn’t...

Reviving this thread! I also installed the Qa1 torsion bar system in my 1969 Dart and out of 2 shops. No one had been able to align it. I can’t get anywhere close to -.5 camber. Today I crawled under and reset the camber bolts to having the front ones to provide max caster and rear ones in...

I’m currently on the same boat. Was installing new dash vents and accidentally broke a pin. The slider that’s made out of plastic is also brittle. I can try to pull my assembly out and get you some dimensions.

thanks for all the help everyone! I was looking for the hole to hole on the mounting tabs, and possibly the width of the speaker itself, I’ve seen brackets that seem a bit offset. @Dana was able to answer the questions . I do appreciate the pictures, I was looking at the retro sound speaker...