Recent content by 1969superbee

Sorry for the confusion, yes bonded and welded if you read the article.

This is an interesting article. They use 3M structural adhesive to bond the connectors to the floor instead of welding them. Super solid and pretty innovative. Don’t Drop In A Hemi Until You Do These 4 Chassis Mods! - Hot Rod Network

Car is sold, sold, sold...!

Man you guys are a rough crowd...I have been struggling with keeping the car because I love it, or selling it due to personal reasons. I love the cars for the cars as well and don't need the extra 2 grand, I make a very good living. But I do feel the car is worth it and refuse to give it away...

Eastern part of the state - colchester area ! I'm going to give Paul a shout and see if he does thanks !

If anyone has a set of black side moldings please pm me!

Doesn't look bad !

Paint

Put a little elbow into cleaning up the engine bay. Happy to see how solid it was under battery tray with no rust issues at. Original engine bay paint still got a little shine to it. Wiper motor in good shape as well. I'm thinking of pulling the motor to regasket it, valve job and seals and...

4 inch or 4 1/2 ?

Lower half

Build sheet top half

Dave you were correct! After looking at the tag and removing it I found that it had been flipped around and put on upside down. Paint fade lines matched up and I found some gasket glue on bottom side of tag to keep it in place. I put it back the right way thanks !

Sorry for the same question twice didn't think it posted. Thanks again for info ����. Tag hasn't been touched so far as I can tell the way it is surface rusted around edge.. ??...

Is anyone making the side moldings ?