Recent content by 49ersrock

I checked the fusable link and it seems ok. There is also a volt meter in the car as well. I looked at the amp meter and one lug is very loose. Both still are connected to wires. I am going to splice them together to bypass it. I have crackbacks alternator bypass I am also going to install. But...

I have a 67 Valiant with a newer steering column (has the key in it) and it also has an amp meter and a volt meter. I have owned the car for nearly two years but I rarely drive it. I went to drive it the other day, after installing a small Holley Fuel Pump on it. After I wired it up (I wired the...

Dang! That twin fresh air breather is sweet! Do you sell that as well?

Looking forward with your EFI install, that is if you decide to go that way. That's the plan for my 67 Valiant one day

Dodge Dart Hemi Swap Gen III Mounts and Crossmembers Parts - Holley This should work but most likely will need some tweaking

Hooker BlackHeart BHS539 Hooker Blackheart Transmission Crossmember Hoop I wonder if this can be used when installing the A518 into an abody?

I hear ya! I could tell ya plenty of horror stories about firearms requals as well as morons that didnt take care of their stuff. And yea, I wouldnt use a police hemi either.

I am a retired officer was well. Yes, idiling is an issue. However, we had take home issued vehicles, and officers took very good care of them. No one wanted their vehicle down for repairs, and officers that I worked with always made sure the vehicles were serviced on time.

Ha! Yes! I hope all is well!

A Les Gibson sighting! I remember the first day I saw your 70 maroon super bee drive in front of my girlfriends house on Toyota Drive

You mean the vapor barrier on top of the gravel, then the rebar, then the concrete right? That is how its normally done in North Florida.

can you post some pics of the interior?