504DusterIR's latest activity
-
I heard, sometimes, you may need the entire rear end, is that true? IDK. -
504DusterIR replied to the thread Rear end.Ok NICE ,how does the I guess elevation play into this ? If you wouldn't mind explaining it to me
-
504DusterIR replied to the thread Rear end.Ok thank you
-
504DusterIR replied to the thread Rear end.Ok what if it's 2.76?
-
504DusterIR replied to the thread Rear end.Beefing up the 8.25 seems like it would be the easiest as in not doing to much cutting an modifications?
-
The mustang rear could probably be used, as is. The explorer rear uses a long axle and a short one, and needs to be narrowed (probably...
-
504DusterIR replied to the thread Rear end.So if say it is 2.45 , you said higher ratio gears will not bolt up but if I get the gears (3.21 or 3.55) out of a 96 or older they...
-
504DusterIR replied to the thread Rear end.Ok so much good info so much research to do an process, So with all the info so far would it be cheaper an easier to change out the...
-
504DusterIR replied to the thread Rear end.I know someone was asking above where I'm at and the sea level? Im Okaloosa County FL
-
504DusterIR replied to the thread Rear end.How would I tell if it a suregrip ? An I'll watch some videos on how to take cover off ( is it as simple as removing the ten bolts) an...
-
504DusterIR replied to the thread Rear end.I came across articles talking about using mustang 8.8 an I also saw a video on youtube where they used a Ford rear end but had to...
-
mark me down for 2.76.
-
504DusterIR replied to the thread Rear end.Yea I was thinking my gear ratio is of that, some charts that was sent to me say that small block V8 passenger car had gear ratio in...
-
504DusterIR replied to the thread Rear end.All this is very good Information ,I'm at work an then I going to school right after so after I'll try to respond, I drive to work an...
-
504DusterIR replied to the thread Rear end.I was born on a Monday but not last Monday lol
