Recent content by 65 Valiant

mo one? pls take a look... thx

thx for looking but this will not fit my setup...

that would be fine. I can also buy a 3/16 spacer on ebay if the pulley is not deep enough. But easier for me to install without a spacer. thx

Hi guys, after a long period of beeing lazy, i started to work at my 65 Valiant again. Looks like i can get it on the street the next spring. What i now need is a crank pulley-single groove- which must be about 2 3/4 inches deep Small block please. if its not even 2 3/4, let me know what you...

Hi guys, looking for a water pump pulley. One groove. i hope i measured it correctly: from the front of the water pump pulley mounting flange to the front of the vibration damper should be 2,75" who has onefor me?? thx Jan

Hi guys, restoration is going on and i'm now down under the car :-/ TTI headers are installed-very very comlicated in combination with a 4 speed... X-pipe ist also installed but we have some trouble to get the pipes correctly over the rear axle... We have 20,45, 90 and 180 degree pipes...

sounds great. 7 1/4 rear? so that must be a 9" drum. I think the strut spring is the same.and if not i will make it work :-) the adjuster lever spring should be pink. Do not know if it will fit!? you can send it to me in a bubble wrap envelope. this must be the cheapest way to Germany.

I'm looking for 2 really small but major parts.They got lost while rebuilding the brakes. 1. I need one adjuster lever return spring 2. emergency brake lever spring 10" drum brake but not important for this parts i think. Who can help and has this parts? thx JAN

yes, i heared of it... but perhaps someone has some used ones?

looking for a good used set of 318 Poly headers and perhaps a 4 bbl intake. not the stock cast iron headers please;) thx

nice car. can you sendme some additional pictures? might be interested. Will pm you.

damn, that is very dusty... You should clean them up before posting... ;-)

i prefer the old Powell Peralta ones. I had a Santa Cruz "Bod Boyle" which i used in the '90 but its gone now,sorry.

looking for .88 or.94 torsion bars for my 65 Valiant. my 1.06 ones have problems with the headers ;-)

pm sent