Any advice on how to remove the chrome spear trim on the rocker? One side fell off after removing the front screw, but the other side still has clips holding it and I'm not sure how to remove without damaging.
Thanks Robert.
Hi, Does anyone know where to buy the nylon / plastic rocker clips for the chrome spears? The trim I have is good, but all clips were broken and held on only by the screw at the front and the wider gill trim at the back.
thanks
Robert
I'm looking to buy a fiberglass hinged hood with a hemi scoop for my 68. AAR is more than Unlimited but both look similar and I've read old reviews for both. Has anyone here bought a one any would you recommend one of these?
Thanks
Robert
Thanks for all the replies. As it turns out the ground tab is broken. When I manually ground the wiper switch the wipers will now not stop at all even when the switch is in the off position. Haha. Got to like these electrical problems. I tested continuity of the switch terminals as per the...
Hi everyone,
I have a 68 barracuda that I am finally starting up and have run into a wiper issue. It has the variable speed switch and matching motor. The wipers stop in whatever position they are in when you turn the switch to off, and they do not go to the bottom. Any idea as to whether...
I need to buy a fan for the heater blower motor and can't seem to find anyone selling one. Any ideas who would sell one? I have the motor.
Thanks
68 BB Cuda
I replaced the fuel gauge in my 68 barracuda with an ebay one and it's working good. My old fuel gauge didn't work and I've opened it. The fine wire that goes to the A pole is not connected to anything so I assume it has broken and is why the gauge isn't working. All other wires from the I and...
I read your post and was hoping to get a photo of your setup. I'm looking to do something similar on the 68 Barracuda. Do you have a 2 or 3 core radiator in your setup?
thanks
Robert
I have a 99 Dakota R/T with 31000 orig kms. Runs and drives like new. Lots of mods like exhaust, stereo... If you're interested in trade for dakota plus some cash let me know.
This is my first 440 a body install. I have the 440 in the car and purchased the block hugger tri y headers from schumacher. The passenger side has lots of clearance. What is the best way to install the headers on the driver side? do i have to loosen the mounts and lift the motor? or am i...