Recent content by 68ddart

i am looking for hood inserts and call outs for my 69 dart swinger ..let me know if anyone has any or where is the best place to buy new ,thanks

i bought a set of factory exhaust tips and rear hangers for my 68 dart and the gap between the bumper is about 1 1/2 inches ..cant find any good pics to see what looks right ..any pics or suggestions?

thanks

on my 68 dart the wiper blades have 15a and 15 on the arm but they look the same so i assume i can put them on either side?just seemed if they were the same they would have same numbers? can anyone tell me if they are different and if so which one goes on which side?thanks

i ended up buying a after market from year one ..if it dont work out i will let you know,thanks

sounds like a good way to test everything ,i will let you know how it goes,thanks alot

thanks , i will use this as a reference

good suggestion ,but already got new harness coming ..i will have to get better at my questions when asking for help...if the new harness doesnt work i will try swapping the terminals..thanks for the helpful advise..this site has been a great help thru this process..wiring and reading diagrams...

i just purchased a complete engine / front light harness that was modified for electronic ignition from year one part number HU202am for 110.00 shipped..i wont beleive it till i see it but seemed to good to be true ,they guaranteed it to be what i needed...if not i will send it back

thanks for the suggestions,i did compare my old cut up harness to the harness that is not working on my car now ,they plug in the same but wires are in different locations on plugs so that means i will need a new harness under hood...my choices now are vanholics at 170.00 non electronic or herbs...

looking for some suggestions..i have a 68 dart 270 car that i have changed to 340 engine and i am working on the factory wiring.i recently replaced the underdash wiring and everything looked good and went right in place ..i purchased a under hood kit and it had been modified for electronic...

i need a under hood wire harness for a 68 dart 340 ..pm what you have with price ,thanks

i would but i have already put it back together..but basically i heated up the plastic pins holding the lens to the old bezel while pulling up on the lens then when i was finished i waxed the lens to clean it up then drilled the holes a little bigger than the pins on the new bezel and pushed the...

i ended up using a soldier iron it went well ..thanks again for the info..glad to have this site to go to when in doubt....

i hated to mess up my old bezel but i guess i will..thanks for the info..they dont tell you in the advertising that it doesnt come with the lens ,but i know now...