Recent content by 69PSSWINGER

anyone

anyone had any dealings with them ? good or bad looking @ buying a 700r4 kit for my swinger

thanks guys I will try to get in touch with Damon

Well I got this engine from my Father in law who had it built & it was never installed. I know the cam was a Hughes cam but I can't find the cam card , it is hydraulic & the pistons are Diamond Pistons. The cam sounds very healthy,probably around a 600 lift .

Just got the 416 installed. Just wanting to find out what the redline should be. Has steel crank , H-beam rods,beehive springs ,Crane Gold roller rockers, balanced. Was built by Diamond Back Racing Engines. Thanks

Any idea where I might find the V1H coded material ? This is the green print

Looking for pass. side manifold

Thanks guys

can someone please post a link for the new hoods.someone posted AMD but I couldn't seem to find anything.Thanks

Thanks guys

Looking for a set of 15" ralleys SBP w/caps & rings. Thanks

I bought the bracket kit from Mancinni for $49.95 plus shipping & had a friend that owns an alternator shop get me the alternator New for $79.95 +$5.00 for the plug . Less than $150.00 bucks vs their $250.00.I installed it last week & it looks great. Will have to get back to you on the...

Anyone in the Houston area looking for a clean car.There is a nice 1965 GT at the swap meet in Conroe. swapmeet is SAT & SUN ALSO for $2000.00.fresh 273 ready to go back in,factory air,ps,auto w/console shifter,has a few minor rust areas on rear fender lips & on lower front of doors ,easy...

Thanks guys.

I prefer MSD . I use the 3119's w/ the multi angle boot,they work really well,you can bend the boot the way you need it to help keep them off of your headers or manifolds.