Turns out the situation was strange. I changed the ballast resistor with the same results. I ohmed out my resistor and it was the same as the new one. I checked voltage at the resistor with the key on and had nothing. Checked my choke wire and alternator and had battery voltage. I went back to...
Reviving an old thread because once again this forum has saved my ***. I have been working on my old dodge for several months. Went to start it, engine cranks and dies when the key is released. If I crank it and barely release the key enough to release the starter it runs. Of course tons of crap...
I know it's a long shot but I'm looking for a torque convertor inspection cover for a 518 trans. I removed a 727 trans from my 75 D100. I assumed the cover was the same but it's not. Thanks.
I'm putting a feeler out for an 8.75 "A" body rear axle housing. I live in Martinsville, In. just southwest of Indianapolis. Would prefer to pick up if within a reasonable driving distance. I have axles. My axle tube is bent and haven't had much luck finding someone who could straighten it for...
Check out this thread. 65 glass install . I followed RUSTYRATRODS suggestions on post#6. " I don't want to steal Rusty's thunder" Worked out good. Lots of soapy water and the plastic sticks from Amazon . Start on the bottom and work your way around. Don't work up both sides and try to finish...