Recent content by AbodyNewbie

Would be nice to have lots of both!!!

Thanks!!! So far so good.

Yeah. It turned out to be quite a turd. Floors and frame rails were all toast and there’s almost 3/8” bondo in places.

Just a mild cam I think and some headers. He can play with it more when he gets older!!!!

Thanks. Couple more months of Saturday’s and should be lookin good!!

Thanks!!! We having a blast!!!

been plugging away during this crazy COVID. The boy has been doing great picking up on skills as we go!! Getting ready to replace both quarter panels and finish up couple more rust repairs and maybe get it painted and sitting on the floor!!!

Found this on eBay. It’s way easier to use that the one in the mopar manual. We’ve got the new front clip mocked up and almost all the measurements check out....except the one circled in red. It’s 1/4” short. We put the hood and fenders back on and everything seems to fit really good...bit...

Gorgeous car!!!!! Where is it located?

You need the upper it lower. Think there’s a few at national Moparts I saw while I was looking around.

Yeah. The cowl is mint!!! Gonna swap that out once the firewall and frame is secured.

Went shopping for a front left frame rail and inner fenders (just needed the top flanges) and came home with this deal. Left frame rails seem to be impossible to find....this new front clip has a small hole in the left frame rail but it’s in a spot we can graft a chunk from one of our rights...

where do the pm’s go? I swear I saw it and now it’s gone...

who is this oldmanmopar. Seems to be a legend around here!!!

Hi everyone. Really need to get some guidance on this. We are just getting ready to install new frame rails front an rear and lots of sheet metal. I have this drawing which shows all the measurements the car should be and I want to double and triple check everything. I know this is a...