Recent content by acidspitstormchild

Need this factory 4bbl 273 linkage

For some reason my post disappeared. If junkyardhero doesn’t have any I’ll get back to you. Thanks for the offer

Most consistent measurement I came up with was 51.75mm 2.0375 inch or 2 3/16 inch for the total length. I came up with 1 and 12/16 for the thread length. Sorry about the incompetence.

I just sent him a message. Hopefully he’s got it. Haven’t had luck elsewhere. There’s a machine shop said they could make them for me but it won’t be cheap

Probably gonna just make one

brake caliper lost a bolt the other day. Can’t seem to find this style for sale at any hardware or auto shop. There’s a similar one for the 05-2010 ram or Durango but upon inspection it was the wrong size. If anyone knows off hand where to find this It would help me a lot. Thank you.

I’m not sure how different the 67 is to the 65 but my steering column came out pretty easy. I also did order that quick fix rubber boot for the coupler. I would go for that u joint style but I’m sure it’s more money than I’d want to spend. Perhaps in the future I’ll go for it!

Yea it sure is

This one doesn’t have the roll pin

Alright guys been a tough few days health wise but I’m in the garage and I am trying to get this coupler clamp to work with me. Any tips? Kinda need to use it because the coupler had no lip to punch the tabs to. In other words the clamp is all that’s keeping it shut. Thanks in advance.

Hey guys it was no problem, I was being overly cautious. Splines were nice and clean. Got it out Thursday. Gonna just take my time and get it nice again. Thanks as always

thanks remytherat I figured as much. I’ll do the best I can. How did it go back on wv64signet? Was it just as bad coming off? I read someone who had trouble getting theirs off AND back on too. They ended up busting the new coupler seal and clamp during reinstall. Makes me question if I should...

Got tired of laying around the house so went to tackle this loose coupler. Seemed easy enough looking at Steering Coupler Rebuild "How To" . Removed the bolt at the end of the coupler. Started pulling the column but it just removes the shaft from the coupler. I wanted to remove as an assembly...

just wanted to finish up the thread and say everything was put back together and driving may 12. Had to have a brain tumor removed so I’ll be down for a bit. What’s left: got to redo the fuel system and refurbish the steering coupler and I should have a decent ride. Thanks

Hey thank you that’s helpful. I will look into that