Recent content by ADHD426

  1. A

    [WANTED] FBO or Rev-N-Nator Ignition Module

    I am looking to pick up a used one. Let me know if you have one. Thanks. Andrew
  2. A

    Bare Engine Comprtment

    I have a bare engine compartment. Nothing on the firewall, 71 Duster /6 converting to 340. It came that way so I don’t know what was where electrical wise. Can someone point me in the direction of a diagram or list of electrical components that are on the firewall? Are there any that can be...
  3. A

    [SOLD] Rear 8 3/4 10" SBP Drums, backing plate, shoes, hardware

    Sold. Thanks everyone.
  4. A

    [Found!] Strut Rod Washers

    Thanks! I’ll let you know soon. One person said he had some, I’m waiting to hear back on that they’re the right ones. If not I’ll take yours.
  5. A

    [Found!] Strut Rod Washers

    Are the same size as the 73 and up washers?
  6. A

    [Found!] Strut Rod Washers

    Looking for a set of strut rod washers for the later model of rods. Thanks! Andrew
  7. A

    [SOLD] Rear 8 3/4 10" SBP Drums, backing plate, shoes, hardware

    I'll get shipping quotes this weekend.
  8. A

    [SOLD] Rear 8 3/4 10" SBP Drums, backing plate, shoes, hardware

    PMs responded to, all the pieces are there, nothing missing.
  9. A

    Help Confirm My Steering Box Setup

    Looking for some confirmation here. I've done a lot of research and just want to double check. I have a 73+ center link, idler, and pitman. I have a manual steering box with a small sector. All of these pieces should get along right? All going in a 71 Duster. Thanks! Much appreciated.
  10. A

    [SOLD] Header-Back Dual 2-1/2 in. Exhaust Kit for Mopar A-Body

    I’ll go to storage and get the picture.
  11. A

    [SOLD] Header-Back Dual 2-1/2 in. Exhaust Kit for Mopar A-Body

    I have a JEGS 2.5" exhaust kit. Brand new still in the box. I am going a different direction since I got TTi headers, and I have heard the kit does not line up well. I travel up and down CA for work and can meet somewhere off 99 or I5. Or if you want to try and ship them, that works too! $175...
  12. A

    [SOLD] Rear 8 3/4 10" SBP Drums, backing plate, shoes, hardware

    $50 or best offer Andrew
  13. A

    [FOR SALE] Timken 8 3/4 Axle Bearings and Seals Set7, 6815, 8704S, 8695s

    Timken Axle Bearings and Seals Set7, 6815, 8704S, 8695s Hello I have 2 of each of the above mentioned items. I went green. New never used. $100. Andrew
  14. A

    Steps Prior to 340 Engine Install

    I have a 71 Duster. The engine compartment is bare apart from the K-member, and the front suspension is all new. Is there anything that I should install, that would be easier to do, before bolting the engine to the K-member? I have TTI headers, should I put those on before putting the engine in...
  15. A

    Control Arm Boots Upper or Lower?

    Can someone tell me which are the upper and which are for the lower? These are from energy suspension. Thanks.
See more
Back
Top