Recent content by BadFish67

Looking for a set for a 1967 Barracuda please

I'm running 30 spline Moser axles with a spool. 2900# and running mid to high 9's for years.

Why would you even think of putting a Ford 8.8 into a Mopar??? Whats wrong with you :)

I'll be selling mine next week but I'm going to be selling it with the whole Biondo CO2 shifter setup.

I run a Wilson plate system and i love it. Its a little more money than the NOS, but it does come with the purge valve too. The small Wilson plate system will do from 50HP to 250HP.

Go with a system like this from Canton. Yes its expensive, but it wont leak and it works great. I have it on my small block and never need to worry about it. http://www.cantonracingproducts.com/cgi-bin/commerce.cgi?preadd=action&key=22-823

Has anyone ever seen a tech guy get under your car and measure where the drive shaft loop is??? I just cant see that happening.

Be careful with that stock 360 block. I'm running one and mine is 600HP without nitrous. The stock 360 block is not made for what we are doing and its only a matter of time before you break a cap. That's why i'm getting all the parts now for a R3 W9 motor.

Perfect...thanks so much!!!

Can someone please give me the measurements where to place the "fish in the circle" deck lid emblem. I have a fiberglass deck lid that I want to put the emblem on. Thanks

Does anyone know who makes a side view mirror block off plate? I'm looking for one for my 1967 Barracuda drag car. Thanks

Yep, thats the plate you need.

It depends on the transmission, converter, and how the 360 is balanced.

Let me know if you want a complete 1967 Barracuda small block K member with steering box and brakes for your car. I just took it out of my Barracuda and looking to sell it. I'm also in NC rear Raleigh.

Test and tune is $10 for the car and $10 to get in. http://www.rockinghamdragway.com/