Recent content by Baxter61

I added them, not sure why they’re not showing, I’ll try again

Edelbrock 2735 Torker 340 intake manifold. Intake has been cleaned and painted with high temp engine enamel, and all the threads have been chased. Intake is unported. $240 plus shipping from Oregon City, OR 97045.

Carter 9635SA carb. Rebuilt with a new Edelbrock kit. Has electric choke. $190 shipped in the continental US from Oregon City, OR 97045. PayPal accepted.

4.030 bore with a 6.123 rod and 3.58 stroke

New KB107 +030 pistons and rings for sb motors. $350 shipped in the continental US from Oregon City, OR. Message me here!!

Sorry, inbox should have room for a message now. However I found the specs and it’s a PTC 11”, should be around 2200, not sure that’s enough of what you want

I have one, where are you located?

No idear

$240 shipped

That I don’t know; we just took it down to oreillys and had them size one up, I don’t remember the part # or size

I can’t find my dial calipers right now but my tape measure shows about 1” 1/16, maybe 1” 1/8 at most

Holley carb. Not sure of size. Not seized, throttle and vacuum pod all move. Looks like it could use a cleaning and a rebuild kit and be good to go. $140 shipped in the continental US from Oregon City, Or

Edelbrock ld340 intake. Intake has helicoils and has been carved out for a spread bore carb. Also needs a new helicoil in the right rear outer carb stud hole if you want to use that one. The thermostat housing holes were helicoiled down to 1/4-20. That said the remaining threads chased good...

Edelbrock Torker 340 intake for Sb la motors. Intake has been cleaned and painted with high temp engine enamel. There is a helicoil in one of the carb stud holes, all other threads chased good. $260 shipped in the continental US from Oregon City, Or.

Cast aluminum valve covers for Sb motors. They have been cleaned and painted. $140 shipped from Oregon City, OR in the continental US.