Recent content by Beatnik

2nd pic

Nice Holley 4779 750cfm mechanical secondary carb and Summit -6 AN line. Little time on complete rebuild. Ready to bolt on and go. Has non stick gaskets, 50cc secondary accelerator pump,threaded brass jet extensions with notched secondary float, tygon seals on the idle mixture screws, new...

PM sent on remote mirror

Here's the latest combo on the Duster. US Mags U101 polished slots 15x5" w/2.5" bs 205/70-15 radials 15x9 w/5" bs (mini-tubbed & springs inboard) 325/50-15 Nitto drag radials Switched out the racey race Draglites and 165r skinny fronts for these. Going for a tough "Day 2" kinda look. So far...

Set of small block LA stamped rockers with shafts, hardware and new pushrods. Used these in my 360 for awhile before building my 5.9 Magnum. These are just sitting around. $60 shipped lower 48! PM me! Thanks FABO!

Selling these Magnum covers. They are in good shape, no nicks or scratches in them. They were on a 318 Durango. Little dusty, and could use some clean up underneath. Baffles intact and come with the caps you see. $130 shipped lower 48. PM me! Thanks FABO!

BUMP! $40 shipped!

I used the 2630...

No brainer! Just swapped in a rebuilt 5.9 into my Duster, all the accessories from an LA swap over, get either a Magnum intake or drill the heads for LA intake, or new Iron Rams which is what I did from Hughes so I could re-use my Eddy Air Gap. Just make sure you use a neutral balanced convertor...

Another pic just for kicks

90* adapter and bolt as shown. Good shape cast iron, off my LA360. $50 shipped to the lower 48! PM me if interested! Thanks FABO

Another one

More pics

Ran this in the Duster and was an excellent cam, motor was bone stock late '70's 360 out of a pickup with an Air Gap and Holley 750 and it ripped!. Swapped motor out for rebuilt 5.9 Magnum and saved the cam out of the old LA 360. Maybe 300 street miles on it. Real nice shape. No lifters...

Just got this going this fall with ironside (Andre) here on the board here in Kalamazoo. 5.9 Mag out of a Ram for $300. Rebuilt it stock bore block and stock rotating assembly. Hughes roller, and Iron Ram heads. Re-used my LA Eddy air-gap and 750dp. Runs really really strong. No dyno tests but...