Recent content by BIGLOVE

Yeah I just used a caliper to measure. I assume my machinist checked them since he said to run them unbushed seemed like if people were running them steel on steel the clearance was.0007 ish

picked up my 72 340 from the machine shop, 340 .030 over speed pro l2316 pistons, 341865 rod castings, eagle cast crank. The rods i sent were not bushed for floating pins so i asked him to verify. Well i pick them up no bushing. took it home and measured pin at .984od and the .986 id on the rod...

scored a 67 date code 383 short block standard bore for 120 bucks 10 minutes from my house. My 67 Dart gt will be happy now.

What do you want for it?

Well poop that a bit far at this point I will keep it in mind. If I can’t find one closer.

Hard top where in Florida?

Sorry Dart 2dr

Needing a roof skin. As Close to central Arkansas as possible. But willing to travel for the right deal. Thanks Sorry 67 Dart 2 door hardtop. Or anything I can cut up to make some patches.

will you ship?

would you be willing to sell the roof or pieces of said roof

Thank you very much.

Any ideas. I have looked far and wide. Any help would be appericated.

a few Mopar guys are chatting at http://irc.everywherechat.com:8000/?room=moparsonly&usesun=false&skipjscript=true stop by and say hi

A couple of Abodies guys are chatting at http://irc.everywherechat.com:8000/?room=moparsonly&usesun=false&skipjscript=true Stop by if your not doing anything

Has anybody used one of these systems. Im thinking of getting one for the dart instead of use old parts trying to make it work. My Dart is about to become my daily and i gots to have some air.