Recent content by bigpig41

I would be interested also, if anyone could post the approximate cross sectional area at mid intake port of a STOCK non ported Street Hemi cast iron head and/or a race hemi head.

SOLD to first personal message

yep : lost phone,internet,electric after worst of storm went over . yep, lost everything right after the eye went over. No phone,internet,electric until 2 hours ago. first res ponder to this add seems to be following through appropriately and I'm waiting for his $$$ will go down the...

Part No. 69HR00016 Grind No. HR-226/345-2S1-10 For Engine 1964-up Plymouth-dodge-chrysler "LA" v-8 273-340-360 & 67-up 318 cu.in. Lift at cam intake lobe .345 inch Duration at .050 = 226.0 Lift at cam exhaust lobe .352 inch Duration at .050 = 232.0 Lobe separation angle is 110...

to anyone serious about this demon: important to realize that i believe we have two different butterscotch demons pictured throughout this thread.

nice car ! someone needs to start the bidding somewhere and get this thing going Know its a long way from your asking price; but nonetheless a real cash offer good for one week. I'll start the bidding at $16,000.00 cash for the demon and original block for pickup in MN; contingent of...

and post some pics of the restoration and the major components being rebuilt if they were .....i.e. transmission, rear end, short block

in reading this entire thread there are a couple references by members of having seen the car for sale in the recent past on this forum. Was the car built by another board member here before you purchased it a year before this thread was started ? Or did you do the paint and engine ?

what does the engine tach with those gears and wheels at 70 m.p.h. ?

would help greatly to get a much more complete pic set here on this website. Most people that would be a potential buyer are already looking for your car with searches and re-checking a certain number of websites regularly. don't make someone call or e-mail you to find out if somethin else about...

sold? no pics posted since september?

could you post pics of the areas where the paint is beginning to bubble? was the compression ratio left at its original 10.5:1 or higher when rebuilt? are all the body panels still the originals? thanks

Is the engine all stock? compression,cam,rods,heads etc. ??? what's rear end ratio?

SIGH !!!!!!!!!!!!!!!!!!!!!!!!!!!! finally sold guys........went to TN to a real nice couple for $14,000.00 without any of the throw-ins I had listed on this site. Truck sold off of an old add I had on American Dream Cars website where it was listed for $14,500.00. Came down 500.00 making...

We ALL would like to have somethin for nothin. But reality is we usually get what we pay for and I had payed up when I bought the Li'l Red 10 years ago......but have had a lotta fun.....and only want to sell because I want to buy a mopar car. I don't mind people puttin negative or positive...