Recent content by Boris

Need some advice folks. I would like to put 15" wheels and tires on the fish, 225 x 60 x 15 on the rears and 195 x 60 x 15 on the front. My question is what back spacing on the wheels do i need? toolmanmike i posted this in Jan. of this year and you responded to me, but i have one other...

I also have a disk brake conversion for the front and that will put to a 5 on 4.5" bolt pattern. i am looking at putting 15" wheels on it.

I am Thanks for responding. I have a 5 on 4" bolt pattern now and i am replacing my rear end with a 8 3/4 with a 5 on 4.5" bolt pattern W/disk brake conversion. I think you are correct about the range not front and back. i wanted to check to make sure.

Need some advice folks. I would like to put 15" wheels and tires on the fish, 225 x 60 x 15 on the rears and 195 x 60 x 15 on the front. My question is what back spacing on the wheels do i need? toolmanmike i posted this in Jan. of this year and you responded to me, but i have one other...

I picked up one for my 64 Barracuda. Looks great, works very good and is worth every cent.

Thank you for the information. That gives me a direction to go with.

Need some advice folks. I would like to put 15" wheels and tires on the fish, 225 x 60 x 15 on the rears and 195 x 60 x 15 on the front. My question is what back spacing on the wheels do i need?

180 degree thermostat.

Thanks for the reply. I was worried i was running to hot.

I have a 64 Barracuda that i just put a 318 in and a three core aluminum radiator. It wants to run between 190 and 200 degrees. What temp should i be running?

Thanks for thanks reply

Thanks for the info, the disk brake changeover is in the plans.

Any suggestions for a 8.25" or a 8.75" rear end swap for my Barracuda? I just replaced the stock 273 motor for a 318 and i want to replace the 7.25" rear end that is in the car now.