Recent content by buckshotbishop

Looking for a slant six manual trans daily driver. preferably 64-72 2 door a b or d100 im located at 93451, and can make a day trip to check anything nice out.

489 sold locally 741 still available *Note it weighs 70lbs with gears and is in California I don't have a greyhound station near me.

I have a super six set up with kickdown linkage that I've been sitting on for forever. Original springs are missing and the carb needs a thorough rebuild. The throttle shaft has a vacumme leak and will need a bushing (you can wiggle it up and down alot). I do have the slightly longer kickdown...

Stock 340 iron intake. The grey is epoxy primer which has held up on a running engine just fine. $50 plus shipping from 93422

Have a bare 489 case with endcaps and adjusters, and a 741 case with a yolk and open diff with 3.23 gears. The gears are a bit rusty, so i can pull them and the diff if the buyer wishes $50 each plus shipping from 93422

Have a set of small bolt pattern american racing outlaw II for sale. There's a small section of road rash on one, and they could use a polish or paint. The factory clear coat is starting to flake. No center caps 175 plus shipping from Atascadero Ca Tires are shot and I'll be removing them...

found it this morning thanks guys

I've been afk from here for quite a while, and its not a mopar but my grandpa's 71 Tr6 was stolen this morning. My grandpa has owned it as long as I can remember. If anyone sees it please contact the Bakersfield police. It has a hard top, the plate is 200pog and it has a green hornet sticker on...

the rallye dash is missing 72 and up fenders

Dutra Dual exhaust manifolds Slant 6 found this today in norcal

if that blue is a metallic single stage you might want to make a test panel for cutting and polishing before you start on your car.

at car shows the sequential injected and turboed/supercharged era correct engines get the majority of my attention. The oddball stuff like a turboed 2.0l nissan in a datsun 1600 roadster and a spitfire with a toyota 1.6l and 5 speed result in me actually talking to the owner if their there, so...

give it a day or a few. when my car was originally re painted the peel was terrible but after a few weeks it flattened out

if its a metallic sanding and cc wont always work, the metallic can pull out and ruin it.one solution would be to sand it flat then apply more to get a gloss. 50-55 could be a bit cold for it if you can spray around 65 it will most likely turn out better. How long has it been scene you sprayed it?

i like it and am concidering somthing simmelar for my valiant. the other photos are just black though. also, i'm assuming your from central or south america due to the cashew tree in the background