Recent content by convx4

I found these replacements that will work with 5/8 heater hose. Dorman 56358 Heater Hose Connectors - 5/8 In. Hose X 3/8 In. Npt X 1-5/8 In. Long Nipple or Four seasions 84722 Dorman HELP! 3/8, 5/8 Inch Heater Hose Fitting - 56365

Long a go I gave up on finding the original clips. Now I just look for universal clips that would do the needed job. Crest Automotive is local to me and is a supplier to body shops. They have a web site . Universal Type Moulding Fasteners - Collision Repair Fasteners - AUTOMOTIVE FASTENERS...

I have married the two together. Its hard to find the correct outer wheel. This one I made with an AMC center. Its easier to find Chevy truck 15x8 outer hoop and then use mopar 15" centers. Also new outer 15" hoops can be bought and then reuse Mopar 15" centers.

FOUND 2/12/24

wanted 1970-74 198 slant six connecting rods with part number 2951260 Looking for a set of six.

Classic industries has 11" also. I'll let you look up the part numbers.

Classic industries has them BRAKE STRUT 10"B-body MN431003 $27 PAIR BRAKE ACTUATOR LEVER 10" B-BODY MN431006 $47 PAIR

I removed the resistor spring wire and installed a jumper wire the same gauge as the rest of the wiring.

Last winter I made new wiring for my 65 coronet. I wanted to make some changes and up date things. This is a list of some of the things done. Wires colors and size (gauge) are all the same as factory. Factory wiring diagram is mostly correct except for the changes I wanted to make. Drew...

I narrow and straiten 8 3/4. This one I'm putting together right now. For me its easier to body work/ grind the rust out then DA the finish, because its thicker metal.

In the AC post you made I was refering to 1965 B-Body evaporators, needing to be reproduced, as I cant find any listing for sale. Also if you could make 134A cross flow condencers that have the factory mounts and hose locations, making it a direct replacement, I think many people would buy...

Thanks to all who contribute to FABO and allow me to learn some thing new and be able to keep my old junk running. I have put together some information that some might find helpful. I have not completed the how to make a gauge tester like the C-3826. Fuel gauge calibration If you have a...

I believe that I have a pair of SBP 8 3/4 backing plates, I'll have to look for them. E-mail me a t convx4 at yahoo.com I don't always log on when I visit FABO

I am currently working on making my own wiring harness on my 65 coronet. I chose to do this because I wanted to make some modifications to the way it is wired. I also am adding relays to these: headlights, high speed on the heater/AC blower motor,, Ac clutch, power top. I have been planing...