Recent content by Dart_440

Looking for a 1967 Dart Rear Bumper, preferably re-chromed or in very good condition. Let me know what you have. Thanks, Bryan

No vin stamp pad. It's a 66', someone swapped out for the B/E tail shaft.

Slip yoke. I updated the listing and photos.

Picked up an 18 spline A833 with a package deal along with some other Hemi parts that I will be selling off. I don't know much about the trans. It's in decent shape, been sitting on a shelf for a while, surface rust on the shaft. I believe based on the numbers it's a 1966, it does not have a...

I don't have the money or need for the games. I wish I did. You should be proud! Sounds like you a raising a great kid! Good Job! I hope he succeeds.

I'm interested.. How much?

any pics you could attach or send me? thanks, Bryan

Thanks for all your opinions and help. I will let you know how it goes. I went with the same one I had in there which was the 274. It should be up and running in a couple weeks. Thanks again!

Yeah I hear ya.. Honestly I want to be able to tune it and drive 500 miles a year on the street. But I'm hoping its no slouch on the track as well. I guess I'm looking for something that's gonna push the limits of both. I just pulled the box of the cam I had in it. I was wrong. It's the comp...

I have 26" tires. I would like to swap out the converter in the future but it might be a while.

Should I be looking a little bigger maybe the xe274? https://www.summitracing.com/parts/cca-cl21-224-4/overview/make/dodge

Great thanks for the input.. I'm gonna look into it.

I'm planning to order a new cam today and I'm still undecided which I should go with. I have a 383 that is 30 over, rods and mains are 10 over. Pistons are flat tops I don't know much else about them. Stock closed chambered heads with headers, RPM intake, 700 holley and pertronix distributor...

Do you have a 67-69 dart trunk lid? Or a 67' dart rear bumper? Thanks Bryan

I have the opposite issue, I have the 3 pin in my 67. I have been considering swapping to the single pin connector. I found this.. the parts look so different not sure if its possible to just swap them out. I will probably just find a wire connector for the 3 pin and use the center wire.