Recent content by Demon499

Good afternoon. I was tuning my car today and it does not to want to idle below 900 rpm. This is with the idle adjuster screw all the way out. When I looked down into the carb all 4 butterfly's seem to be closed. Thanks....................Ted

I am beginning to assemble the windows on my Demon and there are a bunch of hardware that goes inside. I have gotten both of the window assemblies inside both doors. Now its time for the glass. I have a new set of parts for the windows but I have never been down this road before. If anyone has...

I have to replace the lower strut rods on my 74 Dodge Dart. My question is do I have to remove the disc brake assembly when you take the lower arm off. Your input is welcome. Thank you in advanced.......................Ted

I will get you a picture for it tomorrow (Saturday) Thank you.

Are you looking for the chrome trim that goes on the hood?

OK,it is yours. Please give me an address so I can go to the post office and get a shipping cost. Thanks.................Ted

It is a stock style. Not an HV type. Ted

Here is a dual row timing chain with a lower gear that has three adjustments. It fits mopar small block engines. It was in my motor for around five thousand miles. It is in perfect condition. This cost is $35. for it plus the shipping.

Here is a oil pump for small blocks. It was in my motor for around five thousand miles. It is a stock style and it is in perfect shape. This is a Melling unit, made in USA. This is $30 for the pump, plus the shipping. Thank you...................Ted

Has any body ever had the luck finding the plugs for the relieve spring and valve. I've have only able to find a shorter style one. Before I want to put it in I just wanted to know from you guys and gals. Thanks..............Ted

This is on my 360 (now a 408). It has an aftermarket 6 quart pan. It has a problem with the front and rear seals leak. Does anybody have a way to seal it up. Thank you in advance.

If you use the double valve springs leave the inside spring out for break in purposes.

OK It is clean. Send me a P.M.

I can not seem to get the PM clean. I will get in touch with you as soon as posible. Thanks.

This is a tailhousing for a bodys. It has the cast in number C-97477 on it. It uses the 307 bearing. It is $150 for the part plus the shipping. Thank you.