Recent content by dustinmoran91

Sorry i dont check this very often, i would tradr for an 8mm mauser, two 91/30 mosin nagants, two 440 round cans of 7.62x54r, a 1000 rounds of 8mm for the mauser, .223/5.56 ammo, ar-15 magazines, .45 auto ammo, 7mm magnum ammo, a reloading press, .22lr ammo, a bull barrel remington 597, a bull...

$15 shipped

Summit racing double roller timing set for small block. Used maybe 10 minutes and pulled off. Has three key way slots for straight up, advanced and retarded. Asking $25 shipped

I am! Lol

Bump

I was using a howards racing cam with the 1.6 rockers and it made the lift .501 and it may have been that it was to much lift for the flat tops without valve reliefs or the cam was degreed badly. Not sure which

$150

$100 shipped

$60 shipped

After some research i found that the price of these has dropped so i im lowering the price to $70 shipped OBO

$350 and it comes with a big block trans that needs rebuilt, and an extra set of 452 heads

this is one from the internet, it looks identical except that mine has the barbed 3/8'' fittings for the push on rubber fuel line installed in it already. they just screw in and out to change for the different fuel line sizes

its a square bore but i had to have the adapter plate because it was a stock 360 intake that was spread bore, i dont have the list number with me but can get it this evening for you.

this is a generic pump that flows the same as the holley, flows 140 gph at 14psi, inludes fittings for 3/8" fuel line and a new never used fuel pressure gauge that goes up on the motor. this was only run for about 15 minutes or so before being removed. price is OBO

rebuilt this holley 600 and ran it for maybe 15 minutes, took it off and its been sitting since december i think. needs adjusted and tuned. has #66 jets in it. will also include the adapter for spread bore to square bore with allen head bolts to mount it. price is OBO