Recent content by gene mac

did you haave to use a cbody oil pan ffor tie rod clearance?

thnk you so much for the info this has been a big strugle for me

my first monster the 64 polara fastest fn thing on any street in 79 82 hemi 4 sp an 456 gears made sure of that till i put the driveshaft thru the floor sucked none of that stuff fits in this car

cant for the life of me find where to upload photos again

thank u bet them are hard to find got a good deal on some shumacker for now

is this because of a heat issue or a clearance issue mine clear fine although i cant rember what removal may have looked like

i got a good deal on some shumachers but the chrome really sucks along the flanges

probably right there sheetmetal removal on a unibody bad its all structual

whats your tire sidewall clearance lookin like ?

im usin 6 cyl k member an 9 inch spindles

thanks do ya knw the tti #u used what issues were there if any? did u remove the torsion bars to acomplish this task ?looks like ya got a nice fat tire under it what wheel backspace did ya use an tire size ?did you do a drum to disc conversion also?

lookin now

is it because of a heat issue or a clerance issue mine clears valve covers fine

thanks