Recent content by George Fischer

Pretty sure it will. I'll send you a PM.

Will this fit the wheel in the attached pic?

Has anyone out there 3d printed a speedometer bezel for a '70 Dart Swinger? Specifically, I'm looking for the sweep style, and I'd prefer to not chop up either the one I have or one I may be able to buy, just hurts to potentially ruin something that's hard to find. I ordered a set of...

That actually became a problem lol. I wound up using stacks of wood cribbing. The oem jack helped a lot! Amazing how high you can get these with a simple bumper jack.

On the plus side, what I did save has cleaned up quite nicely. The rear bumper is WAY better than the one I had, and most of the trim is super clean after polishing it up a bit.

Here's a bunch. It broke my heart to chop it up, but the wife was less than thrilled about having it out back. I let was was left after I pulled the drivetrain go cheap and have been kicking myself ever since, particularly because I sent off a lot of parts I really needed.

Just cruising through some old posts and came across your ad for the speedometer bezel. Any chance you still have it?

Been a while since I posted an update... So about 18 months ago I fell into another car, a real Swinger 340. Unfortunately, it had been sitting in a closed garage with a dirt floor for 30 years. That being said, pretty much all the sheet metal was shot. In any case, the entire drive-line has...

Thanks!!

I just picked up a spare slant six and complete 3 speed manual transmission. Trying to figure out what exactly I have. It reportedly came out of a 67 Cuda (225 with a 3 on the tree) and was essentially unmolested before the pull. Guy said it ran and drove but when it went on the lift the chassis...

Unfortunately it doesn't look like anything I need. I'd be in the same boat, hate to see them go to waste. Thanks

Do you have any pics?

Thanks so much. Based on this it looks like my donor car is going to have exactly what I'm looking for. That and the factory bucket seats makes it worth dragging the thing across the neighborhood.

Thanks! I can't tell for sure, but in your second pic it looks like the axle housings taper at the pumpkin the same way the LeBaron rear I can get does... One of my buddies that's lending the occasional hand with my project says that he can mod width of anything I get no problem, which also...

I am brand new to this resto business and need a bit of advice. I've done a lot of work on vehicles over the years, but I'm painfully inept at anything related to rear end work. I have a '70 Dart Swinger that's currently in a whole lotta pieces. Started as a quick flip, but you all know how that...