I got a nice pair of Edelbrock valve covers and air filter housing. Comes complete with capscrews, breathers and a mopar logo air filter nut. I’ve decided to go with a stock look. 300$ plus the ride from FtWorth Texas. If you’re local you can pick en up and save on shipping.
I have a set of KB hypereutectic pistons for a .030 over 340. I’ve decided to go with a stroker crank and ordered different pistons. These are new in the box never used. No rings just pistons & pins. I will take 300 plus shipping.
Thanx
Just curious are the seat backs the same width also. I’m doing a barracuda conversion on my signet convertible and wanted to do barracuda interior. So I need to replace my rear seat back with a Cuda seat so the covers will fit.
Yup, I’m debating what route to go. Might go with a 68 hood emblem there or just weld the holes and customize a 2nd gen trunk trim to fit it. I’ve got a 68 barracuda in the works right now. Once it’s done I’m gonna figure something out and finish this one out nicely.