1964 Chevy II nova gasser drag car. Complete roller just drop in your engine and trans. Lots of space for anything!
Full frame( subframe connected)
Completely Tubular front straight axle chassis with Chevy frame mounts.
Tilt front end
Completely new 18 gauge flat floors
Lightweight bucket...
Is it possible to drop in a new hemi in a 68 Dart original k frame. It is an original power steering and power brake car would love to keep this? I am a fabricator/welder and can make just about anything. Wondering if it is possible to move the steering box to clear manifolds or maybe notch into...
I am curious about this also. Now i am not sure what size to make this adapter. Ideally, how much longer would the r154 shaft need to be to be perfect?
Wow thank you so much so just regular steel. I can make that in machine shop. Do you remember what angle of taper was on the end? So the actual I.D is smaller than the shaft? Did you just heat it to get it on there?
Thanks for the pics. What do up make the bushing from what kin of material? Also do u have the length on hand. I am not very good with measurements and don't want to guess. Since your setup is proven to work I figure I can do this right the first time lol
Hope you can help thanks
Is the pressure plate from the dodge dakota v6?
Do u have a picture or diagram of the input shaft adapter? Some dimensions? what did you use to make it?That's the only thing I'm stuck on I believe
I believe he is speaking of the stock starter from a newer 5.7L Hemi engine?
So i found you are using a clutch disc for a toyota picckup truck application.
Just cant find anything on pressur plate or this pilot bearing? Is that all thats needed? I should be picking up an r154 this weekend...
Do you have any part numbers for the clutch disc aand pressure plate?
Care to expand on the pilot bushing please? I dont understand?
correct me if i am wrong but the new slave is a jeep Grand cherokee (zj)? and the master is wilwood 5/8"?
thanks so much
hi all i am new here. What i am looking to do is mate an r154 supra trans to a newer 5.7L Hemi. I have been doing a lot of research lately but cannot come up with a complete list of parts i need. Hope i can get some help!
What Bellhousing?
What Flywheel?
Clutch disc?
Hydraulics? TOB?
Pressure...