Recent content by jason's duster

Taking my 69 340 to the Dyno in a couple of months. Just curious what everyone thinks since we are on the topic. .030 over TRW flat tops 10.5:1 X heads RPM Air Gap Holley fuel pump Holley 670 DP TTI Headers FBO Ignition This is just going to be an engine dyno. Car is not ready yet. I’ll post...

Eagle Rods Forged TRW flat tops I’m not familiar enough with machining to know but I hope everything is right. The builder has a good reputation so of course I put all my trust in him.

Early cast

Thank you for the lesson I love learning something new every chance I get. Still learning as I go. I changed timing cover and water pump.

Nothing on the face so good to go there. Thank you

I have a 72 340 I had built with a forged crank. The guy I purchased crank from sent harmonic balancer with it but not sure if its the correct one. My flywheel will need to be changed for internally balanced crank as well? Any input on these pics and what I need to do would be greatly...

I have a Torker II 340 in excellent condition.

I have the Box out of a 74 swinger. Not sure if it’s the same?

Fronts are GT Radial 1617 Rears are Mastercraft 3917 Front tires have 0 miles rear tires have about 10 miles they’ve been sitting in my shop not out in the elements I understand they were not made yesterday but they are like new no dry rot The wheels are in fair to good condition

Sorry about that it’s empty now

I can ship not sure how much it will cost but I will find out and let you know

I have a 74 Swinger I’m parting out. The car is all original with title. I have used some parts for my project but a lot remains intact. 318 w/904, Hood, Trunk lid, Tail lights, fenders, doors, 8 1/4 rear end, front and rear glass, hub caps, badges, grill etc. It’s hard to list everything but if...

I have a nice set of 4 wheels 5x4 with center caps dress rings and new tires. Fronts 205/70R14 Rears 235/60R14 Im located near Anderson SC 29655 $500

Ok thanks appreciate the info already called machine shop taking down to bare block.

1/2 inch