Recent content by Mharris112241

Just needs the sidecover put on and topped off with oil. Praying for no leaks...

I was definitely getting bound up trying to put it together following the steps in the Passon book and I was confusing myself with a few things. I had it almost all together and the sliding collar on the 3/4 synchronizer kept coming apart. I'll take a stab at it again tomorrow after I decompress...

Found my answer in the passon book. Thanks for the responses

Not sure if my picture posted before, but the bearing shouldn't be able to slide out the front should it even with the correct snap ring? Everywhere I look I'm finding it should be a tapered fit.

Hey everyone I'm assembling an aluminum overdrive case and I was putting the front 308 bearing in. From what I understand the bearing should only be able go in one way, from the inside out with the snap ring holding it from sliding back in or does the bearing retainer help this? My problem is I...