were is the best place to find a complete bebuild kit for my wipers all my rods a bent and cant seem to get them stragiht and where they wont pop off any help will be nice this if for my 74 duster!
I have a 72 duster with a 318 auto in the floor and a 72 4 door dart with the 318 auto did either one of those come with the 8 3/4? Im wondering cause im tryin to get together a good rear for my 74 duster im goin to do a ladder bar kit and all on it! any help would be nice?
and by the way this engine is a procharger engine so the boost factor comes in with bigger ports the more u have done to them the less boost u create at least thats what ive read!
well the mopar heads im looking at are the exact same spec as the eddys to the best of my knowledge all it says it the mopar performance La aluminum clinder heads they have to 202 160 valves intake 171 exhaust 77 cc they are not the cammandos i know that but ive never run aluminum head ive...
Im ordering head this coming up week end and i was wondering what yall think is better for my 408! Im lookning at the mopar aluminum 63 cc heads and the eddys? Which do yall think will be better?
If i go ahead and run a blow trough carb on my motor until i get my supe charger will it be ok or not? Im just wondering cause if i need to buy two carbs then i will but to save money would it hurt anything?
Im goin to run a G force vgate with my 833 but they dont make the kits so im hopeing i can use my good friends Mr gasket mounting bracket and rods od make mine any ideas!
Well thankns for all the replys i know there is a limit on the block by far! but im not goin to be turning this thing really hard very often! But im goin with main support system and i got the forged crank issue fixed my buddy ran around 700 hp on his 340 for years with the juice and a 4 speed...
thamks for the replys well mine is goin to be well over 600 hp when its done cause of the forced induction im not sure exactly what to do if they wont put o forged crank in it i might just not use there engine at all all i know to do is get the motor and change the crank out with either a scat...
I was working with proformance unlimited on building me a short block so it would be ready when i got back to the states but they sent me the invoice and it has tha cast steel crank in it and i wanted a forged steel crank! Does anyone know how much power u can run on a cast steel eagle crank! im...