Recent content by MOPARBURNEM

Ok, it’s (740)418-9571 I’ll be Home from work around 430. Thanks again

Trying to post a video, not having any success. Seems it started to make a tapping noise so I shut it down.

That was after only running a few minutes

Ok, I’m gonna try to get one soon, after only running a couple minutes the oil is back to looking milky again, before I started it, it looked real clean. I’m gonna possibly start looking into someone taking a look at it just so I don’t ruin anything. I have around 2200$ in the engine now and the...

I just ran a vacuum test and it was getting 5 at first then I advanced the timing and got around 12 does this say anything? I don’t have a timing light but can get one

Thanks, getting closer to figuring it out Hopefully

Will look into how to send it to you. Thank you

That’s a wonderful idea, believe I’ll look into one.

I’m gonna look into a 670 street avenger

I just got off the phone with them and they said there wasn’t any antifreeze and the water they spoke of was more than likely condensation, also they said the fuel content should actually only be around 1-2% since it runs lower compared to diesel (they are set up for diesel testing)

Ok I’ll look for that, it’s a Edelbrock 1407 750

I’m gonna call them tomorrow, to make sure it was water and not antifreeze then I’ll ask them about that as well.

Thanks for the education, I’m learning as I go. I’m getting impatient but know what that leads to. I just really want to get this sorted so I can finally drive it. Do you think it’s possible there was still that much fuel still in it even after I changed the oil and swapped another carb on it. I...

Is there a way to test that?

i dont see anything about viscosity temperature, on the paper it says viscosity @100C and the oil weight is 10-30. When the old carb was on it we had to dump fuel down it to get it started but changed the oil once I smelled gas in it. Would changing oil once get all the gas out?