Recent content by PDDart

Thanks, although it didn't seem to have any burrs, I went ahead and took some emery cloth to my shaft...the steering shaft that is. Several taps with a hammer and random bolt, seated the bearing just enough to get the snap ring on. Thanks again!

71 Dart auto, power steering column. During reassembly, I cannot get the ball bearing and housing installed far enough down the shaft to put the snap ring back on. It's almost like the entire assembly needs to be pressed on. Any advice on this?

More pics please

Can you post pics and confirm if small or large bolt pattern? I'm actually guessing large. I'm in Sac, have 4wd and would be more than willing to drive up if it looks good.

Still for sale?

Willing to ship to 95677?

No third member in an 8.25. Still have the entire axle assembly?

Yo, nice to see a fellow Mopar guy from the same town!

Thanks for the advice. I did no more than verify the connections once again and then attempt to start in Neutral and it cranked and fired. It didn't however crank nor fire in Park. Took it for a decent drive and now it starts in both Park and Neutral...all appears to be good. I swear it's acting...

Just installed a new Firm Feel Box which involved disconnecting the steering colum. When in Park, I get nothing and maybe a slight sound from the starter relay under the hood but not sure. When in Neutral, I get a noticeable clunk/click from the starter and then all power is gone...everything...

Ship to CA???

Cool, thanks very much for the response and any follow up!

Have a '71 Dart 318 car and the factory AC was removed before I purchased the car. The dash controls are still installed but the heater does not work. There are two small vacuum lines (side by side) coming out of the firewall that are cut. What do I need to do to get the heater going? Thanks for...

That's awesome! I need one for my mantle too!