Recent content by prostreet68

Sounds strange about the 1 ton wheel cylinders needing to have the mc matched because I know tons of Dodge 2500 guys using the same thing. I never did upgrade my mc which is smaller than the monster mc that I have on my car now. I have never had an issue with mc issues using the 1 ton cylinders...

The mc is out of a b body or something like that came with a Hemi. It has a 1 1/4" bore and I bought it from Napa. Yes it is a drum rear with the disk front...non power.

I did a search and then went thru all the threads on bleeding brake issues and I have yet to find any answers to my problem. All the lines have been replaced along with the 74 Valiant front disks and 1 ton wheel cylinders on the Dana 60 rearend. I did bench bleed the mc before bolting it in. I...

I have a South Bend dual friction behind my 400.

An engine builder I know told me that the 915 heads I have on my 400 will perform better than a set of Max Wedge heads. The reason is that my current build does flow enough volume to use the big ports of the wedge heads. He also said that these 915s with the work(porting) that has been done to...

Starter is sold... Thank you

The heads are 906's and the pistons just below the deck. Also the compression is 9.5 I am in Visalia Ca. Rick

I bought this motor about 3 years ago to put in my 68 Dart but ended up doing the 400 instead. The 383 is fresh and never been fired. It is 30 over,10/10 on the crank,new pistons, rings, bearings,284/484 Mopar Purple cam. It also comes with a torker manifold,dist.,water pump, oil pump. Will...

Here is a couple pictures of the starter...Like I said there hasnt been any power hooked to it. I had it on the motor sitting in the car to build the headers.

I just did some looking on the summit site and it said that it will work on 440 automatics. If you want ...might check on the summit site. But the application list showed 440/auto.

I have a new 9513 Mini Power Master start that I dont have any use for. The starter is new and has never had power connected to it. I tried using it with my 400/Lakewood and the adjustable bracket wouldnt work. I did trim some of the mounting bracket(as per PM) but I had to order another...

I have a 11" big block bellhousing that I want to trade for a big block 10.5". The bellhousing must have been cracked at one time because it has been repaired. I would have used it but I already have a SFI approved 10.5" 130 tooth flywheel and dual friction clutch kit. Thank you Rick

My daughter decided to drop the price to $5000.....

Visalia Ca..... If interested...shoot us an offer and we will discuss it. Rick

All I know is that they are the 17" Mitsubishi wheels. They were on the car when my daughter bought it. Rick